a. Ambient
temperature: 2°C–45°C
b. Relative humidity: less than 60%
c. High-pressure elevation is not more than 1 kilometer
d. Water temperature: 0°C–45°C
e. Deviation of the voltage cannot be bigger than 10%
f. No caustic air
- Wind speed display
- Water show
- Display area corresponding to function keys
- Refrigeration
- Run the wind
- Switch (Long press for two seconds start the machine/shutdown)
- Unplug the appliance during filling and cleaning.
-
Clean the wetted curtain and filter:
- Pull off the plug, remove the 6 screws on the shutters.
- Catch the top of the shutters by hand and pull the wetted curtain out lightly.
- Pull out the filter.
- Pull off the plug, remove screws, take down shutters.
- Wipe the drainage valve at the bottom by hand.
- Use a soft cloth or brush to wash the chassis.
- Clean fouling on pump and filter with a wet brush.
(Clean the water tank, clean the wetted pad, move the machine, long time for use the machine. Please pull off the plug from the socket.)
Repair the machine should be done by a person designated by the supplier.
Use water with pressure 1.5MPa to 0.6MPa. Water temperature should not exceed 45°C.
(Do not put foreign bodies into air intake/outlet. Do not let children near the running machine. Do not put anything into the protecting net.)
- May cause injury or electric shock.
- May cause negative effects.
- May cause wetted pad dissolution, plastic deformation, or breakage.
- Risk of injury from high-speed fan blade.
Safety Notes:
a. Do not use in environments with inflammable gas or long-term direct
sunlight.
b. Do not place on oblique or unbalanced surfaces.
c. Keep air intake/outlet away from walls, curtains, etc.
d. When moving, do not tilt or knock if water tank has water.
e. Do not place flaming appliances where wind can blow over them.
f. Long-term unused: empty water tank, run in blast mode for 10 minutes,
let wetted curtain dry, then unplug.
g. Use socket meeting HC33-1 standard. Install a switch with open spread
>3mm if using power wire.