ECOCOOL4U Logo
Deutsch Deutsch Nederlands Nederlands

System Illumination

This air cooler features ON/OFF, SPEED, SWING, and COOLING buttons, with LED light display and infrared remote control.

a. Two working modes: Cooling, Ventilation;
b. Protection features: Buzzer alarm for water shortage, pump protection;
c. Light display switch control (via remote control).

a. ON/OFF Button: Press the "ON/OFF" button on the control panel or remote control. In standby mode, press to start the machine. The LED screen lights up, displaying current temperature and water level. The "SPEED" and "SWING" settings revert to their state before shutdown. Wind speed defaults to medium (level 2) on first power connection. The wind speed indicator shows levels 1 to 6. Press the "ON/OFF" button again to turn the power off.

This button toggles between Cooling and Air-blast (Ventilation) functions. In Air-blast mode, press "COOLING" to switch to Cooling mode. If the water tank has sufficient water, the water pump will activate for cooling. Press "COOLING" again to switch back to Air-blast mode; the water pump stops. Note: If the water tank is low, the cooler will automatically switch from Cool to Blast mode and the buzzer will alarm.

In either Air-blast or Cooling mode, press "SWING" to start or stop the swing (oscillation) function. The swing indicator light turns on during swing mode and off when deactivated.

Press "SPEED" on the remote or control panel to cycle through wind speeds from 1 to 6 and back. Default speed on initial startup is medium.

a. Functions available in Cooling mode: Swing, Wind Speed, UV, Water Pump.
b. Functions available in Air-blast mode: Swing, Wind Speed.
c. Each restart restores the previous state before power-off.

Always unplug the appliance before filling with water or cleaning.

  1. Cleaning the Wetted Curtain and Filter
    • Remove the screws on both sides of the plastic door.
    • Press the fasteners on the plastic door to open it.
    • Remove the dust filter and take out the cooling pad. Repeat for pads on other sides.
    • Note: Do not use high water pressure. Do not use acidic or alkaline detergents on the wetted curtain.
  2. Cleaning the Water Tank
    a. Unplug the machine. Remove the screws on the shutters and take them down.
    b. Turn the draining valve at the bottom by hand to drain.
    c. Use a soft cloth or brush to clean the chassis.
    d. Use a damp cloth to clean any fouling on the water-level sensor.
    e. Use a brush to clean fouling on the pump and filter.
  3. Cleaning the Cover
    • Use a mild bowl cleaner/decolorizer and a soft cleaning cloth.
    • DO NOT use detergents that produce foam, volatile solvents, or hard brushes, as improper cleaning can damage the machine.
  4. General Long-term Storage
    • Clean the water tank and wetted pad.
    • Move the machine if necessary.
    • Drain all water and run the machine in Air-blast mode to dry components before storage.
    • Always disconnect the plug from the socket.